The cyclic triaxial testing machine is based upon the latest available technology where it can be very easily applied in the hydraulic testing systems. The whole machine-based concept is based upon the closed-loop principle. The system is highly capable of performing several kinds of tests in proper regard to these tenders in that particular field of industry.
Following are some of the features of this
particular machine:
-This machine is based upon servo-controlled
hydraulic closed-loop feedback and mechanism.
-It also confirms properly to the stringent
requirements of the international norms.
-The whole machine is operated through
computers
-The dynamic loading ranges plus -50N- plus
-9KN
-This machine also has the facility to study
the liquefaction behaviour of the soil.
-The advanced analysis software depending on
this machine is also very much helpful throughout the testing procedure.
The components of this kind of machine have
been mentioned as follows:
-Load frame: It is a base with a crosshead and is
fitted with the help of servo valve. This component is very much successful in
conducting the dynamic tests depending upon the adjustments into the height of
the sample. The agreement also provides properties and supports the testing
process.
-Hydraulic actuator for cyclic loading: The
actuator can be referred to as a linear motion device that helps in providing
controlled motion along with stress basis equipment to the whole thing. This
equipment is very much successful in following the commands from the wave
generated with the help of the servo valve.
– Hydraulic power supply: These kinds of
components are very much compact in design and are suitable for the supply of
required flow as well as pressure to facilitate the movement of the actuator.
It also has an oil tank of adequate capacity along with the pump which has been
powered by a three-phase motor. The electrical controls which include
temperature controller also on the one side of the tank and all other surgeries
are on the other side.
-Triaxial cell with accessories: This component of
the whole system helps in ensuring smooth movement of the transfer bar along
with the base of the same. It helps to provide confining pressure and top
drainage with the help of sensors which are for front and back pressure and are
attached very well to the stainless steel base.
-Automatic pressure system: This corporate of
the whole system is very much helpful into line pressure distribution systems
for confining and back pressure with the help of a proper system. The Control
Panel is also a combination of controlled electronics and other kinds of dance.
This company and also has a victim along with packing regulator so that volume
can be changed with the help of sensor fitted think.
-Triaxial cell: This component of the whole system
has actuators and sensors. It can very easily accommodate with the sample size
of 50 MM Diameter. This concept is complete with the help of rubber sheaths.
Hence, the cycling triaxial testing instruments manufacturer help to provide all the above-mentioned components so that overall testing goals are very effectively and efficiently achieved in proper compliance with the international standards.
Comments
Post a Comment